Auto Repair Q&A

Popular

Engine

Cooling System

Brakes

Suspension

Transmission

Exhaust/Emissions

Electrical

Body

Interior

Understand

Directory

Auto Repair Products

mandyadams's picture
2

My car will crank but it makes a metal on metal sound as soon as you crank it but it stops. It will run but soon starts cutting out like its not getting gas. It will not idle very high either. After it goes dead i have to wait about 20 mins then...

mack470's picture
3

How do I remove EGR valve on 2007 Mercury Milan?

mack470's picture
3

My check eng. light code is p2257.From what I understand this code has to do with Air pump system.Where do I look to find this part under the hood,what does it look like?........2007 Mercury Milan 4cyl. FWD.I'd like to know if I can correct his...

bguzzardo's picture
2

I own a 2006 Mercury Milan Premier 4cyl. I have torn the CV boot and would like to replace it, but all of the boots that I can find that fit my car are the Uni-Fit boots which are one piece and thus require that I remove the CV axle in order to...

Cliolap's picture
6

Hi, my problem is i was driving and then i heard a loud noise and then was unable to give my car gas. i had my foot on the gas pedal but it was barely moving. would this problem also have something to do with the foul smell I've been getting in...

jimb52's picture
6

I have a 2010 Milan Premiere, 6 cyl. I've replaced front disc pads many times in the past. But on my Milan i need to replace my rear disc pads, is there anything special i need to know about replacing rear pads?

biggie47's picture
1

I have a 2007 Milan 3.0 Premier. Where is the PCV valve located?

Top Contributors: 4 weeks

Questionare